Galaxy S20 Plus Battery Replacement: Cost & Guide
Share
A Galaxy S20 Plus battery replacement runs about $80 to $130 at a repair shop, or roughly $18 to $40 if you buy the cell and do it yourself. It is a moderate DIY job that restores a phone launched in February 2020 to close to its original all-day runtime, and it costs a small fraction of buying a new device.
The S20+ was the balanced pick in Samsung's 2020 flagship line — larger and longer-lasting than the standard S20, but without the bulk and heavy camera drain of the S20 Ultra. Its 4500 mAh cell feeds a 6.7-inch 120 Hz AMOLED display, and that high refresh rate has always been the biggest draw on the battery. After several years of daily charging, that cell is typically the first component to wear out. If your phone now runs out of charge by mid-afternoon or shuts down unexpectedly, the battery — not the whole device — is what needs attention.

How to check your Galaxy S20 Plus battery health
Samsung builds a battery diagnostic straight into One UI, so you do not need a third-party app to start. Go to Settings > Battery and device care > Battery > Diagnostics. On One UI 5 and later, the S20+ reports a plain-language Battery health rating of Good, Normal, or Weak rather than an exact percentage. Given this phone's age, a "Weak" reading is common — Samsung's way of telling you the cell has degraded enough to justify replacement.
If your S20+ is on an older One UI build that predates the Diagnostics menu, the honest tool is the free AccuBattery app, which measures the real charge flowing into the cell over several cycles and estimates true capacity against the factory 4500 mAh rating. It is a software estimate rather than a lab measurement and needs a few full charges to settle, but over a week or two it reliably confirms whether the battery has genuinely faded before you spend anything.
Signs your Galaxy S20 Plus battery is failing
Battery wear usually shows up as a cluster of symptoms rather than one:
- Galaxy S20 Plus battery draining fast even after a restart, with the display dropped to 60 Hz, or right after a software update.
- Sudden shutdowns at 20 to 40 percent, especially in cold weather, because a worn cell can no longer hold voltage under load.
- The phone runs warm during ordinary tasks like navigation, gaming, or video calls.
- Charging misbehaves: it stalls, jumps percentages, or you see the Galaxy S20 Plus battery not charging even on a known-good cable and adapter.
- Runtime noticeably shorter than the comfortable full day you got when the phone was new.
Safety note: if the back glass starts to bulge, the frame separates, or you feel a raised spot behind the panel, stop using the phone. That is a swollen battery, and it grows more likely as a cell ages. Do not press on it, puncture it, or keep charging it. Power the phone down, keep it somewhere cool and non-flammable, and replace the cell promptly. Swelling is a normal end-of-life failure mode for lithium-ion batteries, but a punctured cell can vent or catch fire, so it is the one symptom you never ignore.
Galaxy S20 Plus battery replacement cost
Here is how the realistic 2026 options compare. The pattern holds across every route: labor is most of what you pay, while the cell itself is inexpensive.
| Option | Typical 2026 price | What you get |
|---|---|---|
| Samsung / authorized service (out of warranty) | $79 – $99 | Technician install, genuine part, mail-in or walk-in at partner locations |
| Local independent repair shop | $80 – $130 | Same-day service; part quality varies by shop |
| DIY replacement | $18 – $40 in parts | The battery cell plus adhesive and basic tools |
Searching "galaxy s20 plus battery replacement near me" will surface both Samsung authorized partners and independent shops, and either is reasonable if you would rather not open the phone. But the price gap is real, and the galaxy s20 plus battery replacement cost drops sharply when you supply the labor yourself.
The exact replacement battery for the Galaxy S20 Plus
The Galaxy S20+ uses a single 4500 mAh lithium-ion cell, sold under Samsung part code EB-BG985ABY. The 5G model is the SM-G986 series — sold as SM-G986U, SM-G986B, SM-G986F, or SM-G9860 by region — while the LTE-only variant carries the SM-G985 code; both use the same battery. Note that the S20+ cell is not interchangeable with the smaller standard S20 or the larger S20 Ultra, so make sure any part you buy is specifically the EB-BG985ABY for the Plus.
When you shop for a Galaxy S20 Plus OEM battery, look for a full-capacity cell that ships with a fresh adhesive kit. You can find the right part and shipping options here:
- Browse replacement batteries at PhonePartPro — full-capacity 4500 mAh Samsung cells, available retail and wholesale with fast US shipping.
- Phone battery replacement guides by model

How to replace the Galaxy S20 Plus battery yourself
Here is the honest difficulty rating first: the S20+ is a moderate DIY repair. You access the battery through the glued glass back rather than the screen, which is more forgiving than a front-glass entry. Budget 45 to 75 minutes and work patiently.
You will need a heat source (an iOpener, hair dryer, or heat gun on low), a suction cup, thin opening picks, a Phillips #00 driver, a plastic spudger, tweezers, and 90% isopropyl alcohol to help release the battery adhesive. This is the general process for how to replace a Galaxy S20 Plus battery:
- Discharge below 25% first. A near-empty lithium cell is far safer to work around if it is accidentally nicked.
- Warm and lift the back glass. Heat the edges to soften the adhesive, seat the suction cup, and slide picks around the perimeter. Go slowly near the rear camera glass.
- Remove the shields and disconnect the battery first. Take out the screws holding the plastic mid-frame, then unplug the battery connector before touching anything else.
- Release the battery adhesive. The cell is held by strong glue. Work isopropyl alcohol around and under the edges to dissolve it and lift with plastic tools only — never pry a metal object against the cell.
- Fit the new cell and reassemble. Seat the new EB-BG985ABY battery, reconnect it, and power on to confirm the phone recognizes it before you re-seal the back with fresh adhesive.
If reading through those steps makes you nervous, there is no shame in handing the phone to a shop — but plenty of first-timers manage this swap with the right tools and a slow, deliberate pace.
After the swap: what to expect
Once the new cell is in, power up and run a deliberate calibration cycle: charge the phone to a full 100%, use it normally until it drains to near 0% and shuts off, then charge uninterrupted back to 100%. The battery gauge needs a full cycle or two to re-learn true capacity, so ignore any odd percentage jumps in the first day — that is normal recalibration, not a defect.
Samsung phones do not use Apple-style parts pairing that locks out the device, so a good replacement cell simply works. On recent One UI versions you may see a one-time notice that a non-genuine battery was detected, and the Diagnostics screen may not report a fresh "Good" rating until the phone finishes recalibrating over those first couple of cycles. Give it two or three full cycles before you judge the result.

Repair vs. upgrade: is it worth it?
An $18 to $40 battery against a several-hundred-dollar replacement flagship is not a close call financially. The S20+ was a balanced, well-built phone with a sharp 120 Hz screen and a capable quad camera, so as long as the glass is intact and it runs the apps you need, a fresh cell buys you years more service for a tiny fraction of an upgrade. A battery is a consumable wear item — the rest of the phone rarely fails at the same time, which is exactly why replacing just the cell makes sense.
There is an environmental case, too, and it is the whole reason PhonePartPro exists: repair, don't replace. Manufacturing a new smartphone consumes far more raw material and energy than swapping a single battery. Replacing the cell keeps a still-capable Galaxy S20+ alive and e-waste out of a landfill — better for both your wallet and the planet.
FAQ
How much does a Galaxy S20 Plus battery replacement cost?
Expect $79 to $99 through Samsung authorized service, $80 to $130 at an independent shop, or roughly $18 to $40 if you buy the 4500 mAh EB-BG985ABY cell and install it yourself. Labor, not the part, is most of the shop price.
How do I check Galaxy S20 Plus battery health?
Go to Settings > Battery and device care > Battery > Diagnostics. On One UI 5 and later the phone shows a Battery health rating of Good, Normal, or Weak. If your build lacks that menu, use the free AccuBattery app over several charge cycles for a capacity estimate — it is a software estimate, not a lab number, but the most reliable gauge available.
Why is my Galaxy S20 Plus battery draining fast?
The 120 Hz display is the S20+'s biggest power draw, and after several years the original cell simply holds less charge. Sudden shutdowns at 20 to 40 percent and warmth during light use point the same way. If drain persists after a restart with the display at 60 Hz, the cell is worn and a replacement restores runtime.
My Galaxy S20 Plus is not charging — is it the battery?
First rule out the cable, adapter, and a lint-clogged USB-C port. If a known-good charger still stalls or the percentage reads erratically, a degraded battery is the likely culprit and a replacement cell usually resolves it.
How hard is it to replace the Galaxy S20 Plus battery yourself?
It is a moderate repair. You reach the battery through the glued glass back, which is more forgiving than a front-glass entry. Plan for 45 to 75 minutes with a heat source, suction cup, opening picks, a Phillips #00 driver, and a spudger. Discharge below 25% first and use isopropyl alcohol to release the battery adhesive rather than prying against the cell.
Will a non-genuine Galaxy S20 Plus battery cause a warning?
Samsung phones do not use Apple-style parts pairing, so there is no lockout. Recent One UI versions may show a one-time non-genuine battery notice, and after installation you should run a full charge-and-discharge calibration cycle so the battery gauge relearns true capacity.